DK19 Epoxy Powder Insulation Coating
A uniform epoxy insulation layer for bus bars and electrical components that need added dielectric protection.
Insulation Applied Directly to the Conductor
Epoxy powder coating applies a continuous insulating layer directly onto bus bars and conductive parts. It is used where equipment needs extra protection against accidental contact, tracking or reduced clearances in compact designs.
EBS applies DK19 epoxy powder coating to bus bars and electrical components, masking contact surfaces so bolted connections remain conductive while the rest of the part receives an even, durable finish.
Coating Services
Bus bar coating
Insulation coating for phase, neutral and connecting bars.
Contact area masking
Joint surfaces masked so connections stay bare and conductive.
Component coating
Coating for custom electrical parts and assemblies.
Fabrication + coating
Bars fabricated and coated in one coordinated job.
Our Process
Our Coating Process
- 01
Part preparation
Surfaces are cleaned and prepared for proper coating adhesion.
- 02
Masking
Contact areas and holes are masked based on your drawing.
- 03
Powder application
DK19 epoxy powder is applied for an even layer.
- 04
Curing & inspection
Parts are cured and checked for coverage and finish quality.
Applications for DK19 Coating
- Bus bars in compact switchgear
- Medium-voltage bus assemblies
- Bus duct conductors
- Custom electrical components
- Refurbished equipment parts
- Areas exposed to dust or moisture
Benefits of Epoxy Insulation Coating
- Added dielectric protection on exposed conductors
- Uniform, durable finish
- Connection areas kept clean for bolted joints
- One shop for bus bar fabrication and coating
DK19 Epoxy Powder Coating FAQ
- What is DK19 epoxy coating used for?
- It is an epoxy powder insulation coating applied to bus bars and electrical components for added dielectric protection.
- Do bolted connection areas get coated?
- No. Contact surfaces are masked so they remain bare and conductive.
- Can you coat bars you didn't fabricate?
- Yes. We can coat customer-supplied parts as well as bars we fabricate.
Get Started
Ready to Power Your Next Project?
Tell us about your switchboard, equipment or electrical service needs. Our team in Los Angeles helps you spec it, build it and get it done right the first time.
